Questions? Call us today!
0333 773 7700

Netgear DGN1000 Setup - NAT

This article shows how you setup a Netgear DGN1000 from factory defaults.

The first step is to connect your router up to the phone line and computer.

Now you will need to open up a web browser and navigate to the router’s interface. To do this type 192.168.3.17 and enter the login details.

The username is admin and the password is Bonding123.

Once logged in, click on Basic Settings. Encapsulation mode should be PPPoA and then underneath that enter the login details provided by your ISP. NAT should be enabled. Click on Apply.

Now navigate to Network Settings, under the Advanced submenu. Change the LAN IP Address from 192.168.3.17 to 10.0.3.x (x is the router number, so 10.0.3.1 for the first router, 10.0.3.2 for the second and so on). The DHCP address range should also reflect the new LAN IP Address. Click Apply.

Once the router has rebooted you may need to type 10.0.3.x into your address bar to login to the router again.

Next click on Select Password from the Maintenance submenu on the left side. The new password should be un0bond1ng.

The final bit of setting up is to input your Sharedband Service information. To do this, click on Configuration under Sharedband on the left hand menu. The Aggregation Server Address is always 5.153.220.1 on our services.

Underneath Sharedband Subscription enter all the information that you were provided and enable Virtual Router Mode. The Virtual router address should be 10.0.3.254, the netmask: 255.255.255.255. Click Save.

Now repeat the process for the second router and so on. The LAN IP Address will change for each router. For example, the second router would have IP of 10.0.3.2 and the third, 10.0.3.3. However each router should use the same credentials.

Is article helpful?